Embedded Files
TBS BRASS BALL VALVES
TBS Brass Ball Valve is manufactured to EN-13828 European Standard. This valve is made of finest brass (CW 617N), hot forged and sand blasted. This ball valve is recommend to use in water distribution system, heating system, hydraulic, pneumatic & agricultural applications.
Full Port
Manufactured to EN-13828
NBR O- Ring
PTFE Seat & Seals
Zinc Plated Steel handle
Manufactured in Italy
Full Port
The valve is full port valve We have provided flow rates for all sizes for you to check suitability for your applications.
Mirror Finish Brass Balls
The chrome plated brass (CW617N) balls are mirror finished & made under extremely stringent tolerance. This ensures a long life & low operating torque.
Blow out proof stem
The stem is bottom entry. Thus blow out proof. A shoulder on the stem does not allow it to blow out. This makes it possible to change/ remove the handle even when the line is under pressure. Also the slot for stem does not protrude through the ball. Thus in full open or full closed position the fluid does not communicate outside the ball or in any part of the stem area. In the same condition there is no pressure on the stem resulting in seal effectiveness or leading to an increase in torque.
Stem Seal
Along with NBR 0-ring we have provided upper & lower seals of PTFE as further protection to seal adding to life of the valve.
MANUFACTURING STANDARD
This valve is manufactured to EN-13828 and recommended for use with potable water and approved by various plumbing institutes across the world.
Page updated
Report abuse